HTC TyTN II Touch Flo 3D

REFID_327

*STEPS 1 - 4 ONLY NEED TO BE CARRIED OUT ONCE. ONCE YOU HAVE FLASHED A HARDSPL AND SECURITY UNLOCKED YOUR PHONE YOU DONT NEED TO DO IT AGAIN WHEN FLASHING ROMS OR RADIOS*

*DO NOT start another process while the flashing process is taking place*
*DO NOT click off of the status bar... Let it stay in the foreground*
*DO NOT let the Screensaver activate*
(any of these can lead to a bad flash and possibly brick your phone)

1. MAKE SURE YOUR KAISER HAS AT LEAST 50% BATTERY POWER FIRST

2. Download and Unzip the Following File:
http://www.4shared.com/file/65469410...dUnlocker.html

3. Flash HardSPL 3.29

Flashing via ActiveSync with USB Lead
1. Copy JumpSPL1.56-KAIS.exe and JumpSPL1.93-KAIS.exe to your device memory (NOT STORAGE CARD)
2. Pull out the battery and reinsert it (this step IS important) *DONT turn phone back on yet*
3. Connect your phone to PC with a USB cable
4. REMOVE SIM and SD CARDS !!
5. Turn phone back on and wait until it syncs with your PC
6. Run a File Explorer, browse to where you copied JumpSPL1.56-KAIS.exe on your device and run it (make sure the USB cable is still connected). If you get a white screen then reset your device and now try JumpSPL1.93-KAIS.exe
7. CLick Continue on phone when prompted
8. After a few seconds the tri colour screen will appear on the phone and "USB" will be displayed at the bottom
9. Unplug the usb cable for 30 seconds and then Replug (phone will not re-sync but still says "USB" on the screen)
10. Right click on the Activesync icon in the bottom corner icon on the computer, goto connection settings, deselect "Allow USB connections" and click "ok"
11. Microsoft ActiveSync icon will now have a red cross in it and the program will say "Connection Disabled"
12. Run the KaiserCustomRUU.exe file on your PC thats in the same folder as the HardSPL .nbh file and follow instructions (ticking boxes and clicking Next) *DO NOT reenable USB Connections in Activesync*
13. Update will goto 100%, the Congratulations screen will be displayed on the PC and the phone will restart
14. If you have problems with Steps 12,13 then try starting again with the JumpSPL1.93-KAIS.exe file.
15. Unplug USB cable from phone then REPLACE SIM and SD CARDS !!
16. Restart phone

**Remember to re-enable "Allow USB connections" in Activesync connection settings after a successful flash**

Este o versiune de test

Tasta StandBy nu functioneaza.


Pentru a intra in standby trebuie sa dezactivati touch flo3d din start/settings/today/items